Call For Paper Volume:4 Issue:10 Oct'2017 |

Investigating Machinability Aspects of Cu-W MMC in Wire Electrical Discharge Machining (WEDM)

Publication Date : 11/07/2015

Author(s) :

S. B. Ubale , Dr. S. D. Deshmukh.

Conference Name :
4th International Conference on Recent Trends in Engineering & Technology(ICRTET-2015) July 2-4,2015 Organized by SNJB's KBJ College of Engineering,Chandwad,Nashik,Maharashtra,India

Abstract :

Copper tungsten (Cu-W) metal matrix composite (MMC) is a very useful material for electrical discharge machining (EDM) electrodes. It has high strength, good wear resistance and exceptional arc erosion resistance. It is often fabricated using powder metallurgy route and is too hard to be machined with conventional techniques. In this paper, an attempt has been made to investigate machinability aspects of Cu-W with 30 wt.% copper and 70 wt. % tungsten in WEDM. The effects of Pulse on Time (Ton), Pulse off Time (Toff), Peak Current (IP), Wire Tension (WT) and Spark Gap Set Voltage (SV) have been investigated experimentally on Material Removal Rate (MRR) and Surface Roughness (Ra).

No. of Downloads :



Web Design MymensinghPremium WordPress ThemesWeb Development

Conference organizers are invited to submit conference proposals. Contact:

July 3, 2017

International Conference on Recent Trends in Engineering and Technology published by IJMTER

May 10, 2016
Prof. Rahulkumar M. Sonar Program Director, ICRTET'2015 Conference Venue: SNJB's Late Sau. K. B. Jain College of Engineering Chandwad

National Conference on “Advances in Engineering and Technology for Sustainable Development” @ Government Polytechnic, Nagpur (MS) , Published By IJMTER

February 24, 2015
Currently Being Held @ Government Polytechnic, Nagpur (MS), INDIA Date: 27th February,2015 Published & Proceeding By: IJMTER Published in Volume-2 , Issue- 2 February-2015

We welcome innovative Research from Researcher.

September 30, 2014

Welcome to International Journal of Modern Trends in Engineering and Research

July 21, 2014