Call For Paper Volume:4 Issue:10 Oct'2017 |

Modelling of cutting temperature using RSM during machining of alloys

Publication Date : 28/02/2015



Author(s) :

Prof. Seema S. Billur , Prof. Ravi Yerigeri , Prof. Vaijanath V. Yerigeri.


Volume/Issue :
Volume 2
,
Issue 2
(02 - 2015)



Abstract :

In modern industry, trend towards using dry and high speed machining has caused much greater heat dissipation in the chip formation zone and for this reason thermal phenomena play a key role in tool life and machinability of the materials. For the improvement of cutting performance, the knowledge of temperature at the tool-work interface with good accuracy is essential. In the present work, the most simplest and economical technique i.e. tool-work thermocouple set-up is developed for the measurement of the cutting temperature in machining. The performance of the setup is evaluated for the materials like EN-8, Al-380, SS-316 and SAE-8620. Machining tests are carried out for these materials for various cutting parameters using carbide tool. Response surface model has been developed for cutting temperature for these materials. Further, the influence of cutting parameters and the thermo-physical properties of work piece materials on response parameters has been studied.


No. of Downloads :

23


Indexing

Web Design MymensinghPremium WordPress ThemesWeb Development

Modelling of cutting temperature using RSM during machining of alloys

February 24, 2015