Call For Paper Volume:4 Issue:8 Aug'2017 |

MODELLING OF TURNING PROCESS FOR FLANK AND CRATER WEAR OF TOOL USING ANFIS

Publication Date : 20/01/2016



Author(s) :

Ms B D Deore , Prof Dr E R Deore , Prof Dr P S Desale.


Volume/Issue :
Volume 3
,
Issue 1
(01 - 2016)



Abstract :

In today’s world the leading industries are very much concerned about reducing down time and to increase the productivity as well as the quality. To increase the product quality the tool should have good performance. Turning process is widely used in the manufacturing operations in all the manufacturing industries. Tool wear monitoring in manufacturing operations is the combined effect of crater wear and flank wear. In direct measurement technique, the tool wear is measured directly at the cutting edge of the worn tool using a tool maker’s microscope or tactile sensors. Whereas, in the indirect measurement technique the tool wear parameters are observed in the form of signals during the machining process which helps to determine the degree of tool wear. In opposite to direct measurement techniques, indirect measurement techniques allow to monitor the cutting process on-line, which is one of the biggest advantages in this method. In addition to that soft computing tools applied for this purpose are neural networks, fuzzy sets, genetic algorithms, simulated annealing, and colony optimization, and particle swarm optimization. In which we have to compares the different techniques to find out the tool wear.


No. of Downloads :

1


Indexing

Web Design MymensinghPremium WordPress ThemesWeb Development

MODELLING OF TURNING PROCESS FOR FLANK AND CRATER WEAR OF TOOL USING ANFIS

January 15, 2016